Waterford Fitmaster

Home

-News

-About the Fitmaster

-Why a Fitmaster

-Fitmaster Owner & Grads

-Featured Studio

-About our Seminars

-Why Fit Kit?

-Catalog

-Stack and Reach Utility

-Front-End Setup Utility

-Downloads and Support

-Upcoming

-Sponsors & Friends

-Contact Us

-Member Login

Join Us

by clicking one of the buttons below:

Fitmaster Stationary Bicycle Fitting Machine 2009 - $2000. Includes quick release levers, quick release angle adjustment, 27.2mm seatpost compatibility, ratcheting front angle plate slider bolt, bottom bracket drop decal, base plate ruler, base plate ruler, zero-base upper head tube, mag resistance unit, wheel and drivetrain plus seatpost. Saddle, bars, seatpost and stem not included.

Computrainer Adapter - $100. Lets you connect a Computrainer head to your Fitmaster.

Ratcheting Front Plate Bolt - $20 and Long-Single Slot Plate $50. These are upgrades from the early Fitmasters which eliminate the need for a dedicated allen wrench to move the front plate. It also allows you to adjust the front plate - and make all sizing adjustments - from the non-drive side of the Fitmaster. It really adds convenience to your fits.

Bottom Bracket Drop Label - $5. This label lets you easily calculate an approximate front center for a particular setup. It also lets you locate the approximate theorectical axle position, letting you determine the top of the head tube location. This handy label mounts 3mm above the front pivot shell.

Replacement Angle Plate Labels - $20. Sometimes the labels get tattered in the course of extensive use. Spruce up your machine or add some color to the earliest models. Mounts with good quality rubber cement over a cleaned surface.

Top Tube/ Seat Tube Stainless Steel Slider $200. This precision machined and fabricated piece allows you to adjust the simulated seat tube length and allows the top tube to slide back and forth during fit setup and adjustments. The dado'd in rule gives you an easy to read center to center measurement and fits as standard 28.6mm seatpost clamp. Fits a 25.4mm seatpost. Cut back the length on your old seat tube slider to allow fits for very short frames.

Top Tube/ Head Tube Stainless Steel Slider $250. This precision machined and fabricated piece allows you to adjust the simulated top tube length and head tube height, while allowing the top tube to slide back and forth during fit setup and adjustments. The dado'd in rule sgives you an easy to read center to center measurements. The head simulates a 27mm top tube/head to intersection to top of head tube. You supply 1 1/8" spacers to sumulate any built-in head tube extensions, headset and headset spacers up to 40mm of specers. Fits both 1 1/8" threadless stems and 1" threaded stems. This is a great upgrade for earlier Fitmasters.